Electronic park brake retract tool

Changing the rear brake pads on your car with electronic park brake calipers? You need to release and rewind the electronic park brake.

This requires VCDS, OBDeleven, LAUNCH X431 or other expensive ECU/ODB interface, or taking the motor apart and other DIY methods.

With this simple tool, you can quickly wind back the park brake one side at a time, so the brake remains on on the other wheel while you work.

How to use it:

Please refer to instructions for full detail, simply put, you replace the pads in the normal way but this tool will wind back the electronic motor that will otherwise stop you from being able to install the new (thicker) pads. 

Brake pad change complete no faff no computer connection, quick and simple as a non EPB version!

Compatible with the vast majority of calliper mounted parking brake motors for these brands:

Compatible Vehicle Brands: VW, Audi, Skoda, SEAT, Renault, Nissan, Hyundai, Honda, Jeep, Chrysler, Fiat, Renault

Note: Not affiliated with or endorsed by above brands. Older electronic cable pull systems may not be compatible.

Also handy if you need to release the brake on a car with failed electronics, to assist with roadside recovery.

Many orders from independent garages and vehicle technicians as well as DIY enthusiasts.

Requires a 9v (PP3) Battery - Not included.

Proudly built by myself in Lancashire, U.K. Shipped globally.